Rolling Wedge Milling Drums & Tools for Kubota Skidsteers

The 70/30 rule is a safety and performance guideline for Skidsteers. It states that the rated operating capacity (ROC) should be no more than 70% of the machine's tipping load for track loaders, and 50% for wheeled loaders. The remaining 30% provides a safety margin to prevent tipping during operation, especially when lifting heavy loads or working on uneven terrain.

Our technology uses a patented 'rolling-wedging-lifting' action that exploits the material's low tensile strength. This is fundamentally different from the 'hammer and chisel' impact of carbide picks. The result is a smoother cut, less vibration, significantly less wear on the tools, and the ability to mill without the excessive heat and stress of traditional methods.

Absolutely. A key advantage of Rolling Wedge Milling Tools is the ability to mill asphalt and concrete, even in a single pass, without needing to change tools. Our cutters are also designed to handle reinforced concrete, cutting through many grades of rebar without jamming or breaking. This versatility saves significant time and labor on complex job sites.

Maintenance is drastically reduced compared to conventional systems. While carbide picks often need replacement twice a week, Rolling Wedge Milling Tools typically last 1-3 months. Keeping tool wear even across the drum supports a good finished cut and maximum tool life. A full Milling Drum changeout takes about 20 minutes, versus 1-2 hours for traditional picks.

We offer a range of Rolling Wedge Milling Drum widths to suit various project scales and Skidsteer sizes. Our available cut widths include 18 inches, 24 inches, 30 inches, and 40 inches. This allows you to select the optimal size for your specific applications, from narrow utility cuts to broader surface milling projects, ensuring maximum efficiency.

No, water is not required for the operation or cooling of Rolling Wedge Milling Tools. The unique rolling action prevents the tools from overheating. Water may still be used for dust suppression to comply with local regulations or job site requirements, but it is not necessary for the mechanical function of the milling drum and tools.